Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
This DTC tests the evaporative emission (EVAP) system for a small and large leak when the Vehicle is turned OFF and the correct conditions are met. The propulsion system needs to be OFF for several hours before the small and large leak tests run. The EVAP leak detection pump creates a vacuum across a 0.51 mm (0.020 in) reference orifice. This reference vacuum is then compared to the vacuum level created in the fuel tank to determine if a leak exists
The following table illustrates the relationship between the ON and OFF states and the OPEN or CLOSED states of the EVAP components:
| Engine Control Module Command | EVAP Canister Purge Solenoid Valve | Vacuum Pump | Switch Valve |
|---|---|---|---|
| ON | Open | Pump Runs | Pump Position/Not Venting |
| OFF | Closed | Pump OFF | Vent Position |