Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
The evaporative emission (EVAP) system uses a EVAP leak detection pump to test for system leaks. The EVAP leak detection pump assembly consists of the following components:
- EVAP leak detection pump with reference orifice
- EVAP leak detection pump switching valve
- EVAP leak detection pump pressure sensor
The engine control module (ECM) monitors the pressure across the reference orifice with the EVAP leak detection pump pressure sensor. When all conditions are met, the ECM commands the vacuum pump ON and monitors the EVAP leak detection pump pressure sensor. If the ECM detects the pressure is too low, too high or not stabilized, a DTC sets.