Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON/Vehicle in Service Mode.
- Verify the scan tool parameters listed below display OK:
- EGR Control Circuit Low Voltage Test Status
- EGR Control Circuit Open Voltage Test Status
- EGR Control Circuit High Voltage Test Status
- If not OK
Refer to Circuit/System Testing.
- If OK
- Operate the vehicle within the Conditions for Running the DTCs. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- If the DTC does not set
- If the DTC sets
- All OK.