Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON/Vehicle in Service Mode.
- Verify no other DTCs are set.
- If any other DTCs are set
- If no other DTCs are set
- Verify none of the conditions listed below exist:
- Restrictions in the EGR cooler, EGR cooler bypass valve and passages
- Binding, damaged or restricted EGR valve.
- Exhaust system leaks.
- Exhaust system restrictions.
- Wet or restricted air filter.
- Loose or improperly connected hoses.
- Damaged or missing components.
- If any of the above conditions exists
Repair or replace the component as necessary.
- If none of the conditions exist
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Test or replace the Q14 Exhaust Gas Recirculation Valve.
- If the DTC does not set
- If the DTC sets
- All OK.