Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0231
The fuel pump driver control module detects that the fuel pump current is greater than 14.48 A for 1 s.
P0232
The fuel pump driver control module detects that the fuel pump output circuit voltage is greater than 4.5 V for 0.5 s when the voltage should be 0 V.
P023F
The fuel pump driver control module detects that the fuel pump current is less than 1 A and the fuel pump duty cycle is greater than a calibrated threshold, 50 percent, for 1 s.