Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0089, P228C or P228D
- DTC P0016, P0017, P0090, P0091, P0092, P0096, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0114, P0117, P0118, P0119, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0627, P0628, P0629 or P1682 is not set.
- The ignition voltage is greater than 11 V.
- The engine is running.
- The low side fuel pressure is greater than 275 kPa (40 PSI).
- The barometric (BARO) pressure is greater than 70 kPa.
- The intake air temperature (IAT) is warmer than -10°C (14°F).
- The DTCs run continuously when the above conditions are met for 2 m.
P00C6
- DTC P0016, P0017, P0090, P0091, P0092, P0096, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0114, P0117, P0118, P0119, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0627, P0628, P0629 or P1682 is not set.
- The ignition voltage is greater than 8 V.
- The low side fuel pressure is greater than 0 kPa (0 PSI).
- The diagnostic runs once for each engine start.