LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Engine Controls And Fuel - 1.8L (LKN) - DTC P0010 To P0459) >> Diagnostic Information and Procedures >> DTC P0011 or P0014: Camshaft Position System Performance >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle Off, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
  2. Test for 5 - 9 Ω between the control terminal 2 or B and the low reference circuit terminal 1 or A.
    • If not between 5-9 Ω 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If between 5-9 Ω 
  3. Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
    • If less than infinite resistance 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If infinite resistance 
  4. All OK
scientia non olet · About LEMON Manuals