Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition On/Vehicle in Service Mode.
NOTE: If a crankshaft or camshaft position sensor DTC is set, the Camshaft Position Actuator output control will not function.
Verify DTC P0335, P0336, P0340 or P0341 is not set.
- If the DTC is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If the DTC is not set
Engine Running.
Verify the scan tool parameters listed below do not display Malfunction while commanding the appropriate Camshaft Position Actuator to 10 degrees:
- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Open Test Status
- Intake Camshaft Position Actuator Solenoid Valve Control Circuit Open Test Status
- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Test Status
- Intake Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Test Status
- Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Test Status
- Intake Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Test Status
- If Malfunction is displayed
  Refer to Circuit/System Testing.
- If Malfunction is not displayed
Verify that none of the scan tool Camshaft Position Actuator Solenoid Valve Control Circuit Test Status parameters change from OK or Not Run to Malfunction while moving the related harness/connectors of the Q6 Camshaft Position Actuator Solenoid Valves.
- If Malfunction is displayed
  Refer to Circuit/System Testing.
- If Malfunction is not displayed
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing.
- If the DTC does not set
All OK.