LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Installation >> Park Pawl Actuator Installation

Park Pawl Actuator Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Park Pawl Actuator
GM4378860Courtesy of GENERAL MOTORS COMPANY
Park Pawl Actuator Installation

Callout Component Name
1 Park Pawl Actuator
2 Manual Shaft Detent Lever Assembly
3 Manual Shaft
NOTE: Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.
4 Manual Shaft Detent Lever Hub Pin
CAUTION: Refer to Fastener Caution .

Procedure

  1. Install a NEW manual shaft detent lever hub pin.
  2. Install the manual shaft detent lever hub pin to correct height.

Specification 
7.9 mm (0.38 in) (a)
scientia non olet · About LEMON Manuals