Control Valve Solenoid Body Wiring Harness Installation
WARNING: This page is about a different variant/trim than selected.
Control Valve Solenoid Body Wiring Harness Installation
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Fluid Temperature Sensor Seal
NOTE:
Install a NEW seal. Do NOT reuse the old seal.
|
| 2 | Automatic Transmission Wiring Harness Procedure Ensure you connect all the connectors to the valve body. Tighten 8 N.m (71 lb in)
NOTE:
The bolts are captured with harness.
|
| 3 | Control Valve Solenoid Body Bolt Tighten 9 N.m (80 lb in) |
| 4 | Control Valve Body Bolt [3x]
NOTE:
Hand tighten and follow torque sequence below.
|