LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Strut Bracket Replacement (Rear) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the rear transmission mount bracket (3).
    Fig 1: Rear Mount Strut
    GM4487992Courtesy of GENERAL MOTORS COMPANY
  2. Install the 4 NEW rear transmission mount bracket to transmission bolts (2) and tighten to 100 N.m (74 lb ft) plus 60 - 75 degrees.
    CAUTION: Refer to Fastener Caution .
  3. Install the NEW rear transmission mount bracket to rear mount through bolt (1) and tighten to 70 N.m (52 lb ft) plus 90 - 105 degrees.
  4. Remove the jack stand.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals