Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the automatic transmission range selector lever cable to the vehicle.
- Install the automatic transmission range selector lever cable grommet (2) to the cowl panel.
- Install the automatic transmission range selector lever cable grommet nuts (1) and tighten to 6.5 N.m (58 lb in).CAUTION: Refer to Fastener Caution .
- Reposition the floor carpet and insulation.
- Install the automatic transmission range selector lever cable to the transmission control lever base. Insure the cable retainer (1) is fully secured to the transmission control lever base.
- Connect the automatic transmission range selector lever cable terminal (2) to the shift lever pin.WARNING: After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
- Install the front floor console. Refer to Front Floor Console Replacement
- Install the automatic transmission range selector lever cable (2) to the automatic transmission range selector lever cable bracket.
- Connect the automatic transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
- Adjust the automatic transmission range selector lever cable. Refer to Range Selector Lever Cable Adjustment
- Install the battery tray. Refer to Battery Tray Replacement