LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the park brake and chock the wheels.
  2. Remove the battery tray. Refer to Battery Tray Replacement
  3. Disconnect the automatic transmission range selector lever cable terminal (1) from the transmission manual shift lever pin.
    Fig 1: Automatic Transmission Range Selector Lever Cable
    GM4486520Courtesy of GENERAL MOTORS COMPANY
  4. Press the locking tabs inward in order to release the automatic transmission range selector lever cable (2) from the cable bracket.
  5. Remove the automatic transmission range selector lever nut (1).
    Fig 2: Automatic Transmission Range Selector Lever And Nut
    GM4486771Courtesy of GENERAL MOTORS COMPANY
    WARNING: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.
  6. Remove the automatic transmission range selector lever (2).
scientia non olet · About LEMON Manuals