LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 9T50 (M3E) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the automatic transmission range selector lever cable bracket (2).
    Fig 1: Automatic Transmission Range Selector Cable Lever Cable Bracket Bolts
    GM4486728Courtesy of GENERAL MOTORS COMPANY
  2. Install the automatic transmission range selector lever cable bracket bolts (1) and tighten to 22 N.m (16 lb ft).
    CAUTION: Refer to Fastener Caution .
  3. Connect the automatic transmission range selector lever cable (2) to the automatic transmission range selector lever cable bracket.
    Fig 2: Automatic Transmission Range Selector Lever Cable
    GM4486520Courtesy of GENERAL MOTORS COMPANY
  4. Connect the automatic transmission range selector lever cable end (1) to the automatic transmission range selector lever.
  5. Check the range selector lever cable adjustment. Refer to Range Selector Lever Cable Adjustment 
  6. Install the battery tray. Refer to Battery Tray Replacement
scientia non olet · About LEMON Manuals