Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition Off
- Install the special tool: CH-48027 Digital Pressure Gauge & CH-37287 - 1A Fuel Pressure Gauge Adaptor
- Ignition On - Engine Running
- Verify the following parameters are within 34 kPa (5 PSI) of each other:
- Fuel Pressure Sensor
- CH-48027 Digital Pressure Gauge
- If not within 34 kPa (5 PSI) of each other
- Inspect the fuel system for damage or external leaks before proceeding.
- If a condition exists - Repair or replace as necessary
- If no condition exists
- Inspect the electrical connectors and the ground circuits of the component for poor connections.
- If a condition exists - Repair or replace as necessary
- If no condition exists - Replace the component: B47 Fuel Pressure Sensor
- If within 34 kPa (5 PSI) of each other
- All OK. - Clear All Vehicle DTCs