Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
| Circuit | Description |
|---|---|
| Control | The output circuit is switched to 12 V to activate the component. |
| Low Reference | Fuel Pump Low Reference |
| Component | Description |
|---|---|
| G12 Fuel Pump | The fuel pump has a DC motor that is controlled by a PWM signal to achieve the desired fuel pressure. |
| K111 Fuel Pump Driver Control Module | The control module K111 monitors the fuel system for any condition which may adversely affect emissions. If a condition is detected it sets a DTC and sends a serial data message to the engine control module which then sets DTC P069E. |
The control module K111 supplies the fuel pump with a PWM signal in order to achieve the desired fuel line pressure.