LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls And Fuel - 2.0L (LTG) - DTC P0335 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P05CC or P05CE: Cold Start Camshaft Position System >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
  2. Test for 7-12 Ω between the control terminal 1 or A and the low reference circuit terminal 2 or B.
    • If not between 7-12 Ω 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If between 7-12 Ω 
  3. Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
    • If not infinite resistance 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If infinite resistance 
  4. All OK.
scientia non olet · About LEMON Manuals