LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls And Fuel - 2.0L (LTG) - DTC P0335 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0351-P0354, P2300, P2301, P2303, P2304, P2306, P2307, P2309 or P2310: Ignition Coil Control Circuit >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle & All vehicle systems - Off
    NOTE: It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.
  2. Disconnect the appropriate electrical connector: T8 Ignition Coil
  3. Test for less than 10 Ω between the test points: Ground circuit terminal 1/A & Ground
    • If 10 Ω or greater 
    1. Disconnect the ground connection: Ground terminal
    2. Test for less than 2 Ω between the test points: Ground circuit terminal 1/A @ Component harness & The other end of the circuit
      • If 2 Ω or greater - Repair the open/high resistance in the circuit.
      • If less than 2 Ω - Repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  4. Engine - Running
  5. Verify the appropriate scan tool Ignition Coil Control Circuit Low Voltage Test Status does not display Malfunction.
    • If Malfunction is displayed 
    1. Ignition OFF, disconnect the X2 harness connector at the K20 Engine Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the control circuit.
      • If infinite resistance, replace the K20 Engine Control Module.
    • If Malfunction is not displayed 
  6. Verify the appropriate scan tool Ignition Coil Control Circuit High Voltage Test Status does not display Malfunction.
    • If Malfunction is displayed 
    1. Ignition OFF, disconnect the X2 harness connector at the K20 Engine Control Module, ignition ON.
    2. Test for less than 1 V between the control circuit and ground.
      • If 1 V or greater, repair the short to voltage in the circuit.
      • If less than 1 V, replace the K20 Engine Control Module.
    • If Malfunction is not displayed 
  7. Ignition OFF, install a 3 A fused jumper wire between the control circuit terminal 3 and ground, engine Running.
  8. Verify the appropriate scan tool Ignition Coil Control Circuit Low Voltage Test Status displays Malfunction.
    • If Malfunction is not displayed 
    1. Ignition OFF, remove the fused jumper and disconnect the X2 harness connector at the K20 Engine Control Module.
    2. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K20 Engine Control Module.
    • If Malfunction is displayed 
  9. Test or replace the T8 Ignition Coil.
scientia non olet · About LEMON Manuals