Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief
- Intake Manifold - Reposition Intake Manifold ReplacementNOTE: It is NOT necessary to completely remove the intake manifold to gain access to the fuel injection fuel rail fuel pressure sensor.
- Fuel Injection Fuel Rail Noise Shield - Reposition Fuel Injection Fuel Rail Noise Shield Replacement
- Disconnect the electrical connector (1).
- Remove and DISCARD the fuel injection fuel rail fuel pressure sensor (2).CAUTION: Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Caution .NOTE:
- Do NOT apply force to the plastic housing of the fuel injection fuel rail fuel pressure sensor. ONLY apply force to the attached hexagon.
- Some fuel may leak from the fuel injection fuel rail orifice after the sensor is removed. Dry the area around the orifice using a lint free cloth.
- After removal, the area around the fuel injection fuel rail sealing surface should be inspected. The surface should be free of fuel, dirt, debris and burrs.