Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Charge Air Cooler Inlet Air Tube (2) - Install

Fig 1: Retainer Spring
Courtesy of GENERAL MOTORS COMPANY
Retainer Spring (1) - Engage
Charge Air Cooler Inlet Air Tube (2) - Install

Fig 2: Charge Air Cooler Inlet Air Tube Bolt
Courtesy of GENERAL MOTORS COMPANY
Charge Air Cooler Inlet Air Tube Bolt (1) - Install [2x] 22 N.m (16 lb ft)
CAUTION: Refer to Fastener Caution .
Front Bumper Fascia Replacement - Install