LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Powertrain Mount Balancing - Lower >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Loosen the transmission rear mount bolt (1) at the transmission rear mount (5). Refer to Transmission Rear Mount Replacement
    Fig 1: Transmission Rear Mount Bolt
    GM4212664Courtesy of GENERAL MOTORS COMPANY
  3. Position two floor jacks with wood blocks under the engine and transaxle in order to support the powertrain assembly.
  4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle
  5. Loosen ONLY the engine mount to engine mount bracket bolts (1). Refer to Engine Mount Replacement 
    Fig 2: Engine Mount To Engine Mount Bracket Bolts
    GM4238142Courtesy of GENERAL MOTORS COMPANY
  6. Loosen ONLY transmission mount transmission side bolts (3) at the transmission mount (5). Refer to Transmission Mount Replacement (Left Side)
    Fig 3: Transmission Mount
    GM4507711Courtesy of GENERAL MOTORS COMPANY
    NOTE: Only the transmission mount transmission side bolts (3) should be loosened. Transmission mount bolts (4) should remain tightened during the balancing procedure.
scientia non olet · About LEMON Manuals