LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Balancer Shaft with Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil pump. Refer to Balancer Shaft with Oil Pump Assemble 
  2. Balancer Shaft with Oil Pump (2) - Install
    Fig 1: Balancer Shaft with Oil Pump And Bolts
    GM4176256Courtesy of GENERAL MOTORS COMPANY
  3. Balancer Shaft with Oil Pump Bolt (1) - Loosely install [8x]
  4. Balancer Shaft with Oil Pump Bolt - Tighten in sequence [8x]
    Fig 2: Balancer Shaft With Oil Pump Bolt Tightening Sequence
    GM4176261Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .

    Tighten

    1. First pass  58 N.m (43 lb ft)
    2. Final pass  58 N.m (43 lb ft)
  5. Timing Chain Crankshaft Sprocket Replacement  - Install
  6. Oil Pan Replacement  - Install
scientia non olet · About LEMON Manuals