LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Automatic Transmission Flex Plate (2) - Install
    Fig 1: Automatic Flex Plate Attaching Bolts
    GM2726718Courtesy of GENERAL MOTORS COMPANY
    CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
    NOTE: Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.
  2. Automatic Transmission Flex Plate Bolt (1) - Install NEW [8x]
  3. To prevent crankshaft rotation, install EN-50792  holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flex plate.
    Fig 2: Starter Motor Bolts
    GM2744964Courtesy of GENERAL MOTORS COMPANY
  4. Tighten in the sequence shown.
    Fig 3: Flex Plate Bolt Tightening Sequence
    GM2744962Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
    1. First Pass: 30 N.m (22 lb ft)
    2. Final Pass: an additional 40 degrees using the EN 45059  meter
  5. Remove the EN-50792  holding tool.
  6. Transmission - Install Transmission Replacement
scientia non olet · About LEMON Manuals