LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 2.0L (LTG)) >> Repair Instructions - Off Vehicle >> Engine Block Disassemble

Engine Block Disassemble

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine oil gallery plugs (1, 2) from the rear of the block.
    Fig 1: Engine Oil Gallery Plugs
    GM2726804Courtesy of GENERAL MOTORS COMPANY
  2. Remove the engine oil gallery plugs (2, 3, 4) from the left side and front of the block.
    Fig 2: Engine Oil Gallery Plugs
    GM2726805Courtesy of GENERAL MOTORS COMPANY
  3. Use a suitable hook tool to catch the clip feature and gently remove the engine block coolant baffle (1).
  4. Remove the engine coolant heater (1), if equipped. Remove the engine coolant heater hole plug (2) if the heater is not present.
    Fig 3: Engine Coolant Heater
    GM2726807Courtesy of GENERAL MOTORS COMPANY
  5. Remove the engine oil pressure sensor (1).
    Fig 4: Engine Oil Pressure Sensor
    GM2726809Courtesy of GENERAL MOTORS COMPANY
  6. Remove the knock sensors (1, 4) and bolts (2, 3).
    Fig 5: Knock Sensors And Bolts
    GM2726810Courtesy of GENERAL MOTORS COMPANY
  7. Remove the crankshaft position (CKP) sensor (2) and bolt (1).
    Fig 6: Crankshaft Position (CKP) Sensor
    GM2738938Courtesy of GENERAL MOTORS COMPANY
  8. Loosen the piston oil nozzle assembly bolt (1) and remove the piston oil nozzle assembly (2).
    Fig 7: Piston Oil Nozzle Assembly Bolt
    GM2738959Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals