LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Controls And Fuel - 2.0L (LTG) - DTC P0010 To DTC P0333) >> Diagnostic Information and Procedures >> DTC P00EA-P00EC: Intake Air Temperature (IAT) Sensor 3 Circuit >> Component Testing >> Turbocharger Boost/Intake Air Temperature Sensor

Turbocharger Boost/Intake Air Temperature Sensor

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the B111B Turbocharger Boost/Intake Air Temperature sensor.
  2. Test the IAT sensor 3 by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Intake Air Temperature Sensor (Delco Sensor) table for Delco sensors. The resistance values should be in range of the table values.
    NOTE: A thermometer can be used to test the sensor off the vehicle.
    • If not within the specified range. 

      Replace the B111B Turbocharger Boost/Intake Air Temperature sensor.

    • If within the specified range. 
  3. All OK
scientia non olet · About LEMON Manuals