Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0089, P228C or P228D
- DTC P0016, P0017, P0090, P0091, P0092, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0119, P0128, P0191, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0628 or P1682 is not set
- The ignition voltage is greater than 8 V.
- The engine is running.
- The low side fuel pressure is greater than 250 kPa (36 PSI).
- The barometric (BARO) pressure is greater than 70 kPa.
- The intake air temperature (IAT) is warmer than -20°C (-4°F).
- The DTCs run continuously when the above conditions are met for 60 s.
P00C6
- DTC P0016, P0017, P0090, P0091, P0092, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0119, P0128, P0191, P0192, P0193, P0335, P0336, P0340, P0341, P0365, P0366, P0628 or P1682 is not set.
- The ignition voltage is greater than 8 V.
- The engine coolant temperature is less than 65°C (149°F).
- The low side fuel pressure is greater than 300 kPa (44 PSI).
- The diagnostic runs once for each engine start.