LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Controls And Fuel - 2.0L (LTG) - DTC P0010 To DTC P0333) >> Diagnostic Information and Procedures >> DTC P0033-P0035: Turbocharger Bypass Solenoid Valve Control Circuit >> Component Testing >> Dynamic Test

Dynamic Test

WARNING: This page is about a different variant/trim than selected.
  1. Install a 10 A fused jumper wire between the ignition terminal 1 of the Q40 Turbocharger Bypass Solenoid Valve and 12 V. Install a jumper wire between the control terminal 2 and ground.
  2. Verify the Q40 Turbocharger Bypass Solenoid Valve plunger retracts.
    • If the plunger does not retract. 

      Replace the Q40 Turbocharger Bypass Solenoid Valve.

    • If the plunger retracts. 
  3. All OK
scientia non olet · About LEMON Manuals