Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0010, P0013, P2088, P2089, P2090, P2091
- Camshaft Position Actuator Solenoid Valve=On
- Ignition Switch Position=Run/Crank
- Ignition Voltage=Greater than 11 V
Frequency the DTC runs=Continuously - After the running conditions are met
P0011, P0014
- DTC P0010, P0013, P0016, P0017, P0335, P0336, P0340, P0341, P0365, P0366 = Not set
- Desired Camshaft Position & Camshaft Position=6 to 29°
- Desired Camshaft Position=Does not vary greater than 3° - For greater than 3 s
- Engine=Running
- Ignition Voltage=Greater than 11 V
Frequency the DTC runs=Continuously - After the running conditions are met