LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Controls And Fuel - 2.0L (LTG) - DTC P0010 To DTC P0333) >> Diagnostic Information and Procedures >> DTC P0010, P0013 or P2088-P2091: Camshaft Position Actuator Solenoid Valve Control Circuit >> Component Testing >> Dynamic Test

Dynamic Test

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Disconnect the appropriate electrical connector: Q6 Camshaft Position Actuator Solenoid Valve
  3. Connect a jumper wire between the test points: Low Reference terminal 2/B & Ground
  4. Momentarily connect a 7.5 A fused jumper wire between the test points: Control terminal 1/A & B+

    Verify the component turns On and Off when connecting and disconnecting the jumper wire: Q6 Camshaft Position Actuator Solenoid Valve

    • If the component does not turn On and Off 

      Replace the component: Q6 Camshaft Position Actuator Solenoid Valve

    • If the component turns On and Off 
  5. All OK.
scientia non olet · About LEMON Manuals