Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P1E34
The inverter phase temperature sensor is less than -50°C (-58°F) for 3 seconds. If the fault is detected at the start of a drive cycle the DTC will set after 600 s.
P1E35
The inverter phase temperature sensor is greater than 170°C (338°F) for 3 s.
P1E36
A 20°C (36°F) difference is observed between the individual inverter phase temperature sensor and the average of the Hybrid Electronics Coolant Temperature and the Transmission Fluid Temperature.