LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Hybrid/EV Control System) >> Diagnostic Information and Procedures >> DTC P1E34-P1E36: Auxiliary Transmission Fluid Pump Inverter Temperature Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Vehicle ON.
  2. Verify DTC P1E34, P1E35 or P1E36 is not set.
    • If any of the DTCs are set 
    1. Verify the T6 Power Inverter Module has the latest calibration in Calibration Information.
      • If the T6 Power Inverter Module does not have the latest calibration, program the T6 power inverter module.
      • If the T6 Power Inverter Module has the latest calibration, replace the T6 Power Inverter Module.
    2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
    3. Verify the DTC does not set.
      • If the DTC sets, replace the T6 Power Inverter Module.
      • If the DTC does not set.
    4. All OK
    • If none of the DTCs are set 
  3. All OK
scientia non olet · About LEMON Manuals