Cranks But Does Not Start
WARNING: This page is about a different variant/trim than selected.
When system commands engine Crank, the hybrid/EV powertrain control module 1 will command drive motor 1 to rotate the engine. The drive motor will continue to rotate the engine at a specific RPM until the engine starts and causes increased engine RPM. The hybrid/EV powertrain control module 1 will cease engine rotation if an increase in engine RPM is not observed after several seconds. This function may have the appearance of a start/stall condition.
- Commanded engine torque is greater than 20 N.m (15 lb ft)
- Low fuel level condition not set
- Fuel level sensors DTCs not set
- Engine CMP or CKP sensor DTCs not set
- DTC P16E0 not set