Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Vehicle ON.
- Verify DTC P0A78 or P0A79 is not set.
- If any of the DTCs are set
- Clear the DTC, vehicle OFF for 2 minutes to allow all control modules to shut down.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets, continue to Circuit/System Testing.
- If the DTC does not set.
- All OK
- If none of the DTCs are set
- All OK