LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Hybrid/EV Control System) >> Diagnostic Information and Procedures >> DTC P0A5E, P0A61, P0A64, P0A67, P0A6A or P0A6D: Drive Motor Phase Low Current >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Vehicle ON.
  2. Verify DTC P0A5E, P0A61, P0A64, P0A67, P0A6A and P0A6D is not set.
    • If any of the DTCs are set 
    1. Clear the DTC, vehicle OFF for 2 minutes to allow all control modules to shut down.
    2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
    3. Verify the DTC does not set.
      • If the DTC sets, continue to Circuit/System Testing.
      • If the DTC does not set
    4. All OK.
    • If none of the DTCs are set 
  3. All OK.
scientia non olet · About LEMON Manuals