Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Wheel Speed Sensor (1) - Install

Fig 1: Wheel Speed Sensor
Courtesy of GENERAL MOTORS COMPANY
Wheel Speed Sensor Bolt (1) - Install and tighten 9 N.m (80 lb in)

Fig 2: Wheel Speed Sensor Bolt
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Fastener Caution
Retainer (3) @ Steering Knuckle - Secure

Fig 3: Steering Knuckle Retainer
Courtesy of GENERAL MOTORS COMPANY
Retainer (1) @ Front Brake Hose - Secure [2x]

Fig 4: Front Brake Hose Retainer
Courtesy of GENERAL MOTORS COMPANY
Retainer (1) @ Side Rail - Secure [3x]

Fig 5: Side Rail Retainer
Courtesy of GENERAL MOTORS COMPANY
Retainer (1) @ Radiator Support - Secure

Fig 6: Radiator Support Retainer
Courtesy of GENERAL MOTORS COMPANY
Wheel Speed Sensor Electrical Connector - Connect
Front Wheelhouse Liner Replacement - Install
Verify the repair is complete. Refer to Diagnostic Repair Verification