Temperature Sensitivity
WARNING: This page is about a different variant/trim than selected.
- An intermittent condition may occur when a component/connection reaches normal operating temperature. The condition may occur only when the component/connection is cold or only when the component/connection is hot.
- Freeze Frame, Failure Records, Snapshot or Vehicle Data Recorder data may help with this type of intermittent condition, where applicable.
- If the intermittent is related to heat, review the data for a relationship with the following:
- High ambient temperatures
- Underhood/engine generated heat
- Circuit generated heat due to a poor connection or high electrical load
- Higher than normal load conditions, towing, etc.
- If the intermittent is related to cold, review the data for the following:
- Low ambient temperatures - In extremely low temperatures, ice may form in a connection or component. Inspect for water intrusion.
- The condition only occurs on a cold start.
- The condition goes away when the vehicle warms up.
- Information from the customer may help to determine if the trouble follows a pattern that is temperature related.
- If temperature is suspected of causing an intermittent fault condition, attempt to duplicate the condition. Refer to Inducing Intermittent Fault Conditions in order to duplicate the conditions required.