Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Vehicle in Service Mode.
- Verify that no other DTCs are set except for P2299.
- If any other DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no other DTCs are not set
- If any other DTCs are set
- Verify the brake pedal position sensor or the brake pedal is not binding causing residual brake pressure to be detected.
- If a condition is found
Repair or replace the applicable component.
- If a condition is not found
- If a condition is found
- Verify the scan tool electronic brake control module Brake Pedal Position Sensor Signal parameter changes between Applied and Released when applying and releasing the brake pedal.
- If the parameter does not change
Refer to Symptoms - Lighting .
- If the parameter changes
- If the parameter does not change
- Replace the K17 Electronic Brake Control Module.