Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Vehicle in Service Mode, clear the DTC information with a scan tool.
Verify no other DTCs are set.
- If any other DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- If no other DTCs are set
Verify DTC P0602 is not set.
- If the DTCs is set
1. Program the K17 Electronic Brake Control Module. Refer to Control Module References .
2. Verify DTC P0602 is not set.
  - If the DTC is set, replace the K17 Electronic Brake Control Module.
  - If the DTC is not set
3. All OK.
- If none of the DTCs are set
Verify DTC P0601, P0603, P0604, P0606 or P062F is not set.
- If any of the DTCs are set
  Replace the K17 Electronic Brake Control Module.
- If none of the DTCs are set
All OK.