Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

NOTE: Since most occurrences of this DTC are caused by excessive brake usage, review with the customer the conditions under which the DTC set.

Allow the brakes to cool down before performing test.
Verify that no other DTCs are set.
- If any other DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no other DTCs are set
Verify DTC C10AC does not set while driving the vehicle under normal braking conditions.
- If the DTC sets
  Replace the K17 Electronic Brake Control Module.
- If the DTC does not set
All OK.