Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
C05A3, C05A4
- An open or a high resistance is detected on a wheel speed sensor circuit.
- A short to ground or an open/high resistance is detected on a wheel speed sensor signal circuit.
- A short to voltage is detected on a wheel speed sensor signal circuit.
C10EE
- The tone ring may be demagnetized
- Water intrusion in the wiring harness
- Incorrectly mounted wheel speed sensor
- Debris on the wheel speed sensor or the tone ring
- Missing tooth or teeth on the wheel speed sensor tone ring
- Air gap between the wheel speed sensor and the tone ring too large
- Electrical magnetic interference with the wheel speed sensor harness