Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Test drive the vehicle in a straight line at a speed greater than 20 km/h (13 MPH).
- Verify all scan tool Wheel Speed Sensor parameters are within 1.6 km/h (1 MPH) of each other.
- If any parameter is not within 1.6 km/h (1 MPH) of each other
Refer to Circuit/System Testing.
- If each parameter is within 1.6 km/h (1 MPH) of each other
- If any parameter is not within 1.6 km/h (1 MPH) of each other
- All OK.