Fastener Specifications
WARNING: This page is about a different variant/trim than selected.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
|
|---|
| Application |
| Evaporative Emission Canister Air Inlet Hose Tie Strap |
| Exhaust Gas Recirculation Cooler Outlet Pipe Gasket |
| Fuel Injector Combustion Seal |
| Fuel Injector Seal |
| Fuel Pump Housing Seal |
| Fuel Tank Fuel Pump Module O-ring |
| Oil Pump Housing Passage Outer Seal |
| Throttle Body Gasket |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
|
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Fuel Injection Fuel Feed Front Pipe Nut | 30 N.m (22 lb ft) |
| Fuel Injector Bolt | 5 N.m (44 lb in) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal.
|
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Accelerator Pedal Position Sensor Fastener | 3.5 N.m (31 lb in) |
| Air Cleaner Outlet Duct Clamp | 4 N.m (35 lb in) |
| Air Cleaner Outlet Duct Fastener | 9 N.m (80 lb in) |
| Air Cleaner Upper Housing Bolt | 4 N.m (35 lb in) |
| Camshaft Position Actuator Solenoid Valve Bolt | 10 N.m (89 lb in) |
| Camshaft Position Sensor Bolt | 10 N.m (89 lb in) |
| Crankshaft Position Sensor Bolt | 10 N.m (89 lb in) |
| Engine Control Module Bracket Bolt- Lower | 22 N.m (16 lb ft) |
| Engine Control Module Bracket Bolt- Upper | 9 N.m (80 lb in) |
| Engine Oil Pressure Sensor | 35 N.m (26 lb ft) |
| Engine Wiring Harness Bracket Nut | 9 N.m (80 lb in) |
| Evaporative Emission Canister Purge Solenoid Valve Bolt | 9 N.m (80 lb in) |
| Exhaust Gas Recirculation Cooler Bolt@Cylinder Head | 25 N.m (18 lb ft) |
| Exhaust Gas Recirculation Cooler Bolt@Exhaust Gas Recirculation Valve | 10 N.m (89 lb in) |
| Exhaust Gas Recirculation Cooler Inlet Pipe Bolt | 10 N.m (89 lb in) |
| Exhaust Gas Recirculation Cooler Outlet Pipe Bolt | 10 N.m (89 lb in) |
| Exhaust Gas Recirculation Cooler Temperature Sensor | 45 N.m (33 lb ft) |
| Exhaust Gas Recirculation Cooler Temperature Sensor Bracket Bolt | 10 N.m (89 lb in) |
| Exhaust Gas Recirculation Pipe Bolt | 10 N.m (89 lb in) |
| Exhaust Gas Recirculation Valve Inlet Bolt | 25 N.m (18 lb ft) |
| Fuel Injection Fuel Feed Pipe Bolt | 10 N.m (89 lb in) |
| Fuel Injection Fuel Rail Bolt | 10 N.m (89 lb in) |
| Fuel Injection Fuel Rail Fuel Pressure Sensor | 30 N.m (22 lb ft) |
| Fuel Pump Bolt | 11 N.m (97 lb in) |
| Fuel Pump Power Control Module Fastener | 9 N.m (80 lb in) |
| Fuel Tank Filler Hose Clamp | 4 N.m (35 lb in) |
| Fuel Tank Filler Pipe Bolt | 9 N.m (80 lb in) |
| Fuel Tank Filler Pipe Nut | 9 N.m (80 lb in) |
| Fuel Tank Strap Bolt | 27 N.m (20 lb ft) |
| Heated Oxygen Sensor | 42 N.m (31 lb ft) |
| Ignition Coil Bolt | 10 N.m (89 lb in) |
| Intake Air Duct Bolt | 9 N.m (80 lb in) |
| Intake Manifold Brace Bolt | 10 N.m (89 lb in) |
| Knock Sensor Bolt | 22 N.m (16 lb ft) |
| Manifold Absolute Pressure Sensor Bolt | 5 N.m (44 lb in) |
| Mass Airflow Sensor Bolt | 4 N.m (35 lb in) |
| Oil Pump Flow Control Valve Bolt | 10 N.m (89 lb in) |
| Spark Plug | 17 N.m (13 lb ft) |
| Throttle Body Assembly Fastener | 9 N.m (80 lb in) |