Fastener Specifications

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Auxiliary Battery Positive Cable to Battery Distribution Engine Compartment Fuse Block Nut (LFV)	16 N.m (12 lb ft)
Auxiliary Battery Positive Cable to Engine Wiring Harness Junction Block Nut (LFV)	16 N.m (12 lb ft)
Battery Hold Down Bolt	22 N.m (16 lb ft)
Battery Hold Down Retainer Fastener (Top of Battery)	9 N.m (80 lb in)
Battery Negative Cable to Battery Sensor Nut (KL9)	12 N.m (106 lb in)
Battery Negative Cable Frame Ground Nut	9 N.m (80 lb in)
Battery Negative Cable to Transmission Case Bolt (LFV)	40 N.m (30 lb ft)
Battery Negative Cable to Transmission Case Bolt (LTG)	22 N.m (16 lb ft)
Battery Positive and Negative Cable to Engine Wiring Harness Junction Block Nut	16 N.m (12 lb ft)
Battery Positive Cable to Battery Distribution Engine Compartment Fuse Block Nut (LFV, LTG)	16 N.m (12 lb ft)
Battery Positive Junction Block Cable to APM Module Bolt (HP4)	22 N.m (16 lb ft)
Battery Positive Junction Block Cable to Battery Fuse Block Nut (HP4)	16 N.m (12 lb ft)
Battery Post Negative Cable Clamp Nut	4.5 N.m (40 lb in)
Battery Tray Fastener	22 N.m (16 lb ft)
Body Harness Terminal to Battery Post Negative Cable Clamp Bolt	9 N.m (80 lb in)
Engine Wiring Harness Fuse Block Bracket Bolt	9 N.m (80 lb in)
Generator B+ Terminal Nut (LFV, LTG)	15 N.m (11 lb ft)
Generator Mounting Fastener (LFV, LTG)	22 N.m (16 lb ft)
Generator Mounting Stud (LFV, LTG)	9 N.m (80 lb in)
Multifunction Power Supply Converter Bracket Nut	6 N.m (53 lb in)
Starter Bracket Large Bolt (LFV)	58 N.m (43 lb ft)
Starter Bracket Small Bolt (LFV)	22 N.m (16 lb ft)
Starter Mounting Bolt (LTG)	22 N.m (16 lb ft)
Starter Mounting Fastener (LFV)	58 N.m (43 lb ft)
Starter Solenoid Cable Nut (LFV, LTG)	13 N.m (115 lb in)