Removal Procedure

Front Bumper Fascia Upper Molding (2, 3)» Remove - Front Bumper Fascia Upper Molding Replacement

Fig 1: Front Bumper Fascia Upper Molding
Courtesy of GENERAL MOTORS COMPANY
Raise and support the vehicle.
Remove the 4 wheelhouse liner bolts (1) from the right and left hand wheelhouse liners.

Fig 2: Wheelhouse Liner Bolts
Courtesy of GENERAL MOTORS COMPANY

NOTE: It will be necessary to turn the front tire to the left when working on the right side and to the right when working on the left side. This is to gain access to the bolts.
Remove 3 wheelhouse liner screws (2) from the from the right and left hand wheelhouse liners.
Remove the 9 front underbody front air deflector bolts (1).

Fig 3: Underbody Front Air Deflector
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia Bolt (1) - Left Side» Remove

Fig 4: Front Bumper Fascia Bolt - Left Side
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia Bolt (1) - Left Side» Remove

Fig 5: Front Bumper Fascia Bolt - Left Side
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia Bolt (1) - Right Side» Remove

Fig 6: Front Bumper Fascia Bolt - Right Side
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia Bolt (1) - Right Side» Remove

Fig 7: Front Bumper Fascia Bolt - Right Side
Courtesy of GENERAL MOTORS COMPANY
Carefully push a small nylon wedge between the fascia (1) and the fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia.

Fig 8: Fascia
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia (1)» Remove

Fig 9: Front Bumper Fascia
Courtesy of GENERAL MOTORS COMPANY
Disconnect all electrical connectors.