Installation Procedure

Fig 1: Front Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Transfer components as necessary.
Front Bumper Fascia (1)» Install
Connect the electrical connectors.
Secure the front bumper fascia (1) to the front bumper fascia guide.

Fig 2: Fascia
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia Bolt (1) - Right Side» Install and tighten 4 N.m (35 lb in)

Fig 3: Front Bumper Fascia Bolt - Right Side
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Front Bumper Fascia Bolt (1) - Right Side» Install and tighten 2.5 N.m (22 lb in)

Fig 4: Front Bumper Fascia Bolt - Right Side
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia Bolt (1) - Left Side» Install and tighten 4 N.m (35 lb in)

Fig 5: Front Bumper Fascia Bolt - Left Side
Courtesy of GENERAL MOTORS COMPANY
Front Bumper Fascia Bolt (1) - Left Side» Install and tighten 2.5 N.m (22 lb in)

Fig 6: Front Bumper Fascia Bolt - Left Side
Courtesy of GENERAL MOTORS COMPANY
Underbody Front Air Deflector Bolt (1) - Front» Install and tighten [9x] 2.5 N.m (22 lb in)

Fig 7: Underbody Front Air Deflector
Courtesy of GENERAL MOTORS COMPANY
Install the 4 wheelhouse liner bolts (1) from the right and left hand wheelhouse liners and tighten to 2.5 N.m (22 lb in).

Fig 8: Wheelhouse Liner Bolts
Courtesy of GENERAL MOTORS COMPANY

NOTE: It will be necessary to turn the front tire to the left when working on the right side and to the right when working on the left side. This is to gain access to the bolts.
Install 3 wheelhouse liner screws (2) from the from the right and left hand wheelhouse liners and tighten to 2.5 N.m (22 lb in).
Lower the vehicle.
Front Bumper Fascia Upper Molding (2, 3)» Install - Front Bumper Fascia Upper Molding Replacement

Fig 9: Front Bumper Fascia Upper Molding
Courtesy of GENERAL MOTORS COMPANY