LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Cruze LS, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> Engine Oil Pressure Indicator Malfunction >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON.
  2. Verify the engine oil pressure indicator turns on and off when commanding the All Indicators ON and OFF with a scan tool.
    • If the engine oil pressure indicator does not turn on and off. 

      Replace the P16 Instrument Cluster.

    • If the engine oil pressure indicator turns on and off 
  3. Verify the scan tool Engine Oil Pressure Sensor parameter is 0 psi (0 kPa).
    • If not 0 psi (0 kPa) 

      Refer to Circuit/System Testing.

    • If 0 psi (0 kPa) 
  4. Engine running.
  5. Verify actual engine oil pressure is within specified range. Refer to Oil Pressure Diagnosis and Testing  in Displays and Gauges Component Replacement Reference .
  6. Verify the scan tool Engine Oil Pressure parameter is within specified range.
    • If not within specified range 

      Refer to Circuit/System Testing.

    • If within specified range 
  7. Verify the engine oil pressure displayed on Instrument Cluster (if equipped) is within specified range.
    • If not within specified range 

      Test or replace the P16 Instrument Cluster.

    • If within specified range 
  8. All OK.
scientia non olet · About LEMON Manuals