T19 Power Supply Transformer (MM1)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray Name | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | Not Required | J-35616-14 (GN) | No Tool Required | Not Required | Not Required | Not Required | Not Required |
| II | Not Required | J-35616-40 (BU) | No Tool Required | Not Required | Not Required | Not Required | Not Required |
| III | Not Required | J-35616-64B (LT BU) | No Tool Required | Not Required | Not Required | Not Required | Not Required |
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 - 3 | - | - | - | Not Occupied | - | - |
| 4 | 0.5 | VT/YE | 5985 | Accessory Wakeup Serial Data | III | - |
| 5 | 0.35 0.35 |
YE/BK YE |
625 447 |
Starter Enable Relay Control Starter Relay Coil Control |
I I |
KL9 KL9+MM1 |
| 6 | 0.5 | VT/GN | 39 | Run/Crank Ignition 1 Voltage | III | - |
| 7 | 4 | BK | 2850 | Ground | II | - |
| 8 | 6 | RD/WH | 2740 | Battery Positive Voltage | II | - |
| 9 | 2.5 | RD/GN | 2173 | 12V Regulated Supply Voltage 2 | II | - |
| 10 | 2.5 | RD/YE | 2172 | 12V Regulated Supply Voltage 1 | II | - |
| 11 | 6 | RD/GY | 2840 | Battery Positive Voltage | II | - |
| 12 | 4 | BK | 2850 | Ground | II | - |
| 13 | 0.35 0.35 |
WH WH |
7494 2501 |
High Speed GMLAN Serial Data (-)3 High Speed GMLAN Serial Data (-) 1 |
I I |
KL9+LH7 -LH7+DU11+KL9 |
| 14 | 0.35 | WH | 7494 | High Speed GMLAN Serial Data (-)3 | I | KL9 |
| 15 | 0.35 | BU/BK | 7493 | High Speed GMLAN Serial Data (+)3 | I | KL9 |
| 16 | 0.35 | BU/BK | 7493 | High Speed GMLAN Serial Data (+)3 | I | - |
| 17 | 0.35 | WH | 7494 | High Speed GMLAN Serial Data (-)3 | I | - |
| 18 | - | - | - | Not Occupied | - | - |