LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Bolt EV LT >> Repair and Diagnosis >> Electrical >> Charging Systems >> Plug-In Charging System >> Repair Instructions >> Charge Port Housing Replacement (Dubai)

Charge Port Housing Replacement (Dubai)

Fig 1: Charge Port Housing
GM4533912Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

  • Identify how to disable high voltage.
  • Identify how to test for the presence of high voltage.
  • Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must be followed.

Failure to follow the procedures exactly as written may result in serious injury or death.

Preliminary Procedures

  1. Disable the high voltage system. High Voltage Disabling .
  2. Remove Front Wheelhouse Liner–Left Side Front Wheelhouse Liner Replacement .
  3. Charge Port Door Replacement (Dubai) .
1 Charge Port Housing

Procedure

  1. Disconnect and unclip the electrical connector.
  2. Using a plastic trim-type stick, release the tabs to the charge port housing assembly from inside the fender.
  3. Push outward on the assembly housing.
  4. Enable the high voltage system. High Voltage Enabling .
scientia non olet · About LEMON Manuals