Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Rear

Fig 1: Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing - Rear

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Ensure the bearing is installed squarely into the bearing bore.
1	Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly Procedure Ensure the printing on the bearing is facing upward. A suitable adapter is required to use with the J 8092 driver to install. Press the bearing until the bearing bottoms on the rear case half. Special Tools J 8092 Universal Driver For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure
Ensure the bearing is installed squarely into the bearing bore.

Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly

Procedure

Special Tools
J 8092 Universal Driver
For equivalent regional tools, refer to Special Tools .