LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2016 >> Suburban 3500 HD LT >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case - Mp 3023/3024 (NQH) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Transfer Case Disassemble (Heavy Duty) >> Rear Output Shaft Seal and Bushing Removal

Rear Output Shaft Seal and Bushing Removal

Fig 1: View Of Transfer Case Rear Output Shaft Seal & Bushing
GM1849345Courtesy of GENERAL MOTORS COMPANY
Rear Output Shaft Seal and Bushing Removal

Callout Component Name
1 Transfer Case Rear Output Shaft Seal
CAUTION:

Refer to Transfer Case Seal Removal Caution .
2 Transfer Case Rear Output Shaft Bushing
Follow the steps below for use of the DT-48734  remover/installer.

Procedure

  1. Install the finger section of the DT-48734  remover/installer in front of the bushing.
  2. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out.
  3. Using a wrench on the forcing screw, remove the bushing.
NOTE:

Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection .


Special Tools 
DT-48734  Extension Housing Bushing Replacer
For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals